Detecting 2 ethernet cards
To configure an ethernet card in Linux, you need to enable it in the kernel. Then the kernel will detect your ethernet card if it is at a common IO port. But it will stop there, and will never check if you have 2 ethernet cards.
The trick is to tell the ethernet driver that there are 2 cards in the system. The following line will tell the kernel that there is an ethernet card at IRQ 10 and IO 0x300, and another one at IRQ 9 and IO 0x340: ether=10,0x300,eth0 ether=9,0x340,eth1
You can add that line on bootup at the "boot:" prompt, or in the /etc/lilo.conf file. Don't forget to run:
lilo
That will reload the lilo.conf file and enable changes.
keyword : ethernet card in linux
To configure an ethernet card in Linux, you need to enable it in the kernel. Then the kernel will detect your ethernet card if it is at a common IO port. But it will stop there, and will never check if you have 2 ethernet cards.
The trick is to tell the ethernet driver that there are 2 cards in the system. The following line will tell the kernel that there is an ethernet card at IRQ 10 and IO 0x300, and another one at IRQ 9 and IO 0x340: ether=10,0x300,eth0 ether=9,0x340,eth1
You can add that line on bootup at the "boot:" prompt, or in the /etc/lilo.conf file. Don't forget to run:
lilo
That will reload the lilo.conf file and enable changes.
keyword : ethernet card in linux
posted by Yunan Lasito @ 10:09 AM
0 Comments:
Post a Comment
<< Home